Question: How do I remove a locked emulsion?

Wet your screen on both sides. Spray on the emulsion remover and let it soak in for about 15-30 seconds. NEVER let the emulsion remover dry on the screen. Scrub with a brush until you can see the emulsion start to break down and rinse with a pressure washer.

How do you remove plastisol ink?

Dampen a soft cloth with mineral spirits. Rub the damp cloth directly onto the print screen or item from which you are trying to remove the plastisol ink. Coat the screen with a thin layer of mineral spirits. Alternatively, a thin layer of plastisol ink remover can be sprayed directly onto the item.

How do you reduce plastisol ink?

How to Handle Too Thick Plastisol InkStir the Plastisol Ink. You can fix a thick ink by stirring it. The more you mix an ink prior to pouring it onto your screen printing frame that is on the press, the more it will loosen up. Use an Ink Thinner or Reducer on Thick Plastisol Ink. Add a small amount of curable reducer.19 Mar 2018

Can you clean plastisol ink with water?

Introduction to Plastisol Ink Water-based ink is very easy to clean from the screen: all you have to do is spray it with the hose and it washes away.

Will acetone remove screen print?

You can even remove the ink from screen printing with acetone after heat setting. You can also remove the screen-printing from your shirt using a high-pressure gun and spotting fluid. Removing screen printing is easiest when it is still fresh, as an older print can prove difficult to work with.

What consistency should plastisol be?

For proper printing, plastisol ink needs to be heavy enough to maintain its viscosity throughout the print run while still being thin enough to penetrate the screen easily and evenly. If a stir stick can stand up in the ink, its too thick.

What is reducer in screen printing?

Buy Direct! Curable Reducer is designed for 2 purposes. The first need for reducer is when youre printing wet on wet to prevent the ink from sticking onto the back of the screen, the reducer will make your ink less “sticky.” The second use is to create a softer hand print or reduce the viscosity of your ink.

Contact us

Find us at the office

Varese- Ganan street no. 91, 84563 Mata-Utu, Wallis and Futuna

Give us a ring

Curtis Pietrantoni
+13 637 813 334
Mon - Fri, 9:00-23:00

Join us